When Product Designers Use Computer-Aided Design (CAD) Software to Produce

question 100

Multiple Choice

When product designers use computer-aided design (CAD) software to produce technical drawings in three dimensions, they are using:

• A) lateral system software.
• B) vertical applications software.
• C) utility software.
• D) office productivity software.

---

Definitions:

Stall RPM

The engine speed at which the torque converter or other coupling device can no longer transfer power to the drivetrain, causing the engine to stop or stall under load.

Cranking Motor RPM

The speed, measured in revolutions per minute, at which a starter motor turns the engine during the starting process.

Overrunning Clutch

A mechanical device allowing a shaft to turn in one direction freely but locks to prevent motion in the opposite direction, often used in starter motors.

Starter Drive Assembly

A component of the vehicle's electrical system that engages the engine's flywheel to start the engine.