Examlex
Technician A says that it is possible to replace press-in type rocker arm studs with threaded ones by milling, then using a tap to thread the boss in the head. Technician B says that it is good practice to replace stamped steel rocker arms during an overhaul. Who is correct?
Q2: When the mating surface of an OHV
Q9: It is best to change motor oil
Q11: This parametric procedure is used to test
Q20: The technician diagnosis and completes the _
Q21: Where is the lead acid battery located
Q26: A torque angle gauge is used to
Q29: Technician A says that a fully charged
Q30: Technician A says installing a good used
Q37: The Atkinson cycle design improves fuel mileage
Q59: The PCM controls _ _ and _