Refer to the Exhibit

question 52

Multiple Choice

Refer to the exhibit. An engineer reconfigures the port-channel between SW1 and SW2 from an access port to a trunk and immediately notices this error in SW1's log: *Mar 1 09:47:22.245: %PM-4-ERR_DISABLE: bpduguard error detected on Gi0/0, putting Gi0/0 in err-disable state Which command set resolves this error?

• A) SW1(config-if)# interface Gi0/0 SW1(config-if)# no spanning-tree bpdufilter SW1(config-if)# shut SW1(config-if)# no shut SW1(config-if)# interface Gi0/0 no spanning-tree bpdufilter shut no shut
• B) SW1(config-if)# no spanning-tree bpduguard enable no spanning-tree bpduguard enable
• C) SW1(config-if)# spanning-tree bpduguard enable spanning-tree bpduguard enable
• D) SW1(config-if)# interface Gi0/1 interface Gi0/1