Examlex
When using a puller, tighten the forcing screw slowly and carefully onto the shaft. Check that the puller is not going to slip off center or off the object. Readjust the puller if necessary.
Q3: Planetary gears are held in place by
Q8: Tech A states that based on the
Q17: Technician A states that many automotive technicians
Q24: Which of these transmissions uses two, either
Q38: A screw or bolt with a cross-shaped
Q83: The Alison 1000 series transmissions has two
Q90: Identify the gear ratio of the first
Q137: The dial bore gauge can measure a
Q147: Technician A states that typically, technicians are
Q153: Technician A says that lockout/tag-out is a